CoverCraft Carver OTC Instructions

Thank you for purchasing a Carver Over-the-Tower Cover (OTC). We look forward to making you another happy Carver
customer. Our OTC's for Tournament Ski Boats and Tournament Ski Boats w/ Wide or Pickle Fork Bows are designed to go
over the entire boat including your ski tower and bolt-on swim platform. Our OTC's for V-Hull Runabouts/Modified V-Hull
Boats and Deck Boats are designed to go over the entire boat including the ski tower and integrated swim platform.
Below you will find instructions on how to install your new cover. If you have any questions while installing your boat cover,
feel free to call us at (888) 48-COVER and we can walk you through the process. When you call us here at Carver, you will
get a live person, not a recording because our goal as the leading boat cover manufacturer in the US, is to impress you with
our exceptional customer service.
It may be necessary to spin your wakeboard racks in and to fold and store your bimini top in order to install your new
Carver Cover.
1. Add any padding needed to the windshield, wakeboard racks or any sharp areas that could damage the boat cover.
2. Place the bow end of the rolled cover (the end with the tag) on the bow of your boat and unroll towards the stern or back,
positioning it down the center of your boat as you roll.
3. Slip the front of the cover over the bow and pull the cover open to the sides and over the tower as you work towards
the stern of the boat.
4. Adjust cover fit by pulling cover tight to eliminate sagging areas. These areas may collect standing water or snow and
shorten the life of your cover.
5. Using the reinforced tie-down loops, secure the cover to your trailer with the included tie-down kit (see instructions on
Installing A Carver Tie-Down Kit on the next page). NOTE: The Carver Over-the-Tower Cover is not recommended for
travel.
To remove the boat cover, fold it to the center from each side and roll it from back to front. This will make it easier to repeat
steps 1-5 when covering boat again.
Warranty: The materials and workmanship are guaranteed to be free of defects at the time of manufacture. Warranty
coverage commences on the original date of purchase. The warranty does not cover normal wear, weather soiling and stains
from environmental pollution and/or standing water, cuts from sharp objects, neglect, accident or misuse. The boat cover
must be properly installed, utilized and maintained. The length of warranty is determined by the type of material ordered.
Please visit www.carvercovers.com for detailed warranty information.
Carver by Covercraft Industries, LLC
More Information at CarverCovers.com
or call (888) 48-COVER.
Installing Your Carver
Over-the-Tower Boat Cover
IMPORTANT: Allow cover to dry thoroughly before folding into storage.
212 N. Lyles Ave., Landrum, SC 29356
The Best Covers Under the Sun™