Garage Door Systems ThermaRoll 77 Installation Instructions Manual page 25

SOMFY ROLLIXO QUICK COMMISSIONING
Activating/Deactivating the alarm
The alarm function is factory set to activated. To activate/deactivate the alarm, simultaneously
To activate/deactivate the alarm, simultaneously press the STOP and buttons
press the STOP and down buttons on the control panel until the 4 indicator
on the receiver until the 4 indicator lights flash rapidly.
lights flash rapidly. The alarm emits a beep if it has been activated.
The alarm emits a beep if it has been activated.
Alarm operation
Alarm operation
The alarm is triggered for 2 minutes if the bottom rubber seal is compressed when the
The alarm is triggered for 2 minutes if the door is raised manually.
door is at its closed position. No movement of the door is possible when the alarm is
No movement of the door is possible when the alarm is sounding.
sounding. When the alarm sounds, press a button on a remote control memorised in the
When the alarm sounds, press a button on a remote control memorised in the receiver to stop
receiver to stop it. The alarm can only be stopped with a memorised remote control.
it. The alarm can only be stopped with a memorised remote control.
Alarm operation test
Keygo transmitter required. With the
Alarm operation test
door closed compress the bottom rubber
Press buttons
seal. The alarm will sound, use pre-
simultaneously.
programmed button on handset to turn
alarm sounder off. If the alarm doesn't
The alarm triggers briefl y to indicate
sound it has been de-activated. Reactivate
that it is activated.
using stop and down buttons as above.
Locking out the Panel
 Press buttons
STOP
 Entry into programming mode by pressing button
Entry into motor end limit setting mode via pressing buttons
locked.
The parameter setting of the operating modes is locked, the reverse process aspplies to
The parameter setting of the operating modes is locked, the reverse process applies to
UNlock the panel - ie hold/stop programme.
UNlock the panel
Failure to do so will enable consumer to operate programming mode, this is potentially
dangerous.
Rollixo Quick GuideHW_A5_02.indd 9
25
1 2 3 4
STOP Prog
and on the receiver
STOP
STOP and Prog on the receiver until all the indicator lights flash.
simultaneously on the control panel until all the indicator lights flash.
STOP Prog
1 2 3 4
Prog
1 2 3 4
STOP
1 2 3 4
STOP
1 2 3 4
STOP Prog
on the receiver is locked.
STOP Prog
and
Page 9
+
Prog
1 2
Prog STOP
on the receiver is
12-07-17 14:02
3 4
Prog
25