Table of Contents
Advertisement
(3) Now at the opposite end (safety brake end) move the barrel into position by sliding the shaft through the
endplate notch (with the motor plate located onto the four mounting bolts you will have sufficient room to do
this). Extend the shaft into the pre-fitted safety brake.
3
4
5
!
12
AXLE ASSEMBLY
3
(4) When shaft at non-drive end has been located within the safety
brake you can then position the motor mounting plate fully on the 4
x pre-fitted bolts on opposite endplate and secure with 4 nyloc nuts
provided using a 10mm socket.
(5) LOCK OFF THE NON-DRIVE END SHAFT USING A
POZI SCREWDRIVER, ENSURING THAT THE LOCKING
COLLAR IS TIGHT AGAINST THE MOTOR BARREL.
!
!
!
Advertisement
Table of Contents
