Page 1
BALE SPEAR MODEL 3PBS1, 3PBS2 Published 10/20 Part No. 50073292 OPERATOR’S MANUAL This Operator's Manual is an integral part of the safe operation of this machine and must be maintained with the unit at all times. READ, UNDERSTAND, and FOLLOW the Safety and Operation Instructions contained in this manual before operating the equipment.
Page 2
To the Owner/Operator/Dealer All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded operator who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to be used with all its safety equipment properly attached to minimize the chance of accidents.
TABLE OF CONTENTS SAFETY SECTION ......................1-1 General Safety Instructions and Practices ......................1-2 Operator Safety Instructions and Practices ....................... 1-3 Equipment Operation Safety Instructions and Practices ..................1-4 Connecting or Disconnecting Implement Safety Instructions and Practices ............1-6 Maintenance and Service Safety Instructions and Practices ................1-6 Transporting Safety Instructions and Practices ....................
These parts are made and tested to Bush Hog specifications. Non-genuine "will fit" parts do not consistently meet these specifications. The use of “will fit” parts may reduce equipment performance, void warranties, and present a safety hazard. Use genuine Bush Hog parts for economy and safety.
SAFETY Decal Location NOTE: Bush Hog supplies safety decals on this product to promote safe operation. Damage to the decals may occur while in shipping, use, or reconditioning. Bush Hog cares about the safety of its customers, operators, and bystanders, and will replace the safety decals on this product in the field, free of charge (Some shipping and handling charges may apply).
Page 18
INTRODUCTION The Bush Hog 3PBS1 and 3PBS2 have uses and applications in farming and ranching. They have the capability of quickly and conveniently turning your Tractor equipped with a Bale Spear for lifting, transporting, and placing bales. The 3PBS1is designed to fit three point lift category one tractors while the 3PBS2 work with category one and two three point lift tractors.
Page 19
NOTE: Warranties are honored only if completed “Owner Registration and Warranty” forms are received by Bush Hog within thirty days of delivery of the implement. 3. Record the Model and Serial Numbers on Warranty Page at the front of the Operator’s Manual. Keep this as part of the permanent maintenance file for the Implement.
ASSEMBLY ASSEMBLY Your Bush Hog bale spear is fully assembled at the factory. If applicable, make sure all nuts and or bolts are properly torqued before use of attachment. Refer to “Torque Chart” in the Maintenance Section of this manual.
Page 23
BUSH HOG BALE SPEAR OPERATION INSTRUCTIONS Your Bush Hog Bale Spears should now be assembled and inspected for any evidence of defective or damaged parts before use. Any evidence of damage should be reported to your dealer immediately. This section of the Operator’s Manual is designed to familiarize, instruct, and educate safe and proper bale spear use to the operator.
Tractor with the Bale Spear raised off the ground. If you follow these few safety reminders, you will find that you will quickly become very adept, handy, and skillful at using your Bush Hog Bale Spear. 10.1 Picking up a Bale 1.
Comply with all federal, state, and local laws. 14. When traveling on roadways, transport in such a way that faster moving vehicles may pass you safely. 3PBS1-3PBS2 10/20 Operation Section 4-15...
2. Inspect bale spear for loose, damaged, or worn parts and adjust or replace when needed. 3. Repaint parts where paint is worn or scratched too prevent rust. Paint is available from your local Bush Hog dealer.
Page 45
TO THE OWNER/OPERATOR/DEALER To keep your implement running efficiently and safely, read your manual thoroughly and follow these directions and the Safety Messages in this Manual. The Table of Contents clearly identifies each section where you can easily find the information you need. The OCCUPATIONAL SAFETY AND HEALTH ACT (1928.51 Subpart C) makes these minimum safety...
Need help?
Do you have a question about the 3PBS1 and is the answer not in the manual?
Questions and answers