Table of Contents
Advertisement
Fig. 20a: Removing the Philips screws on the upper and right side of the unit
3. Lift up the access cover of the JRex-IBOX and remove it (see fig. 20a) .
4. The lithium battery is located at the rear of the unit. Remove the lithium battery
from the socket, by pressing the retaining spring to the rear, and pulling the
battery upward.
5. Insert the new battery into the socket.
6. Make sure that you insert the battery correctly. The plus pole must be facing
to the memory!
7. Replace the access cover and brackets for wall mounting and secure these to
the unit by use of the retained screws.
Please observe, that only the retained M3x4 metric screws may
be used for attaching the access cover.
JRex-IBOX – User's Manual
Fig. 21: Platzierung der Lithium-Batterie
Maintenance
Lithium Battery
31
Advertisement
Table of Contents
