Table of Contents
Advertisement
Maintenance
Maintenance
Kontron Embedded Computers systems only require minimal maintenance and
care to keep them operating correctly.
q Occasionally wipe the system with a soft dry cloth.
q Remove persistent dirt by use of a soft, slightly damp cloth (use only a mild
detergent).
Replacing the Lithium Battery
The SBC card of your JRex-IBOX is equipped with a lithium battery.
To replace the battery please proceed as follows:
1. Turn off your system and disconnect the power cord from the power source.
2. Remove the six Philips screws (three on the left side and three on the right
side) and the two screws at the upper side of the device (see fig. 20, and
fig. 20a) . Retain the screws and brackets for later use.
Fig. 20: Removing the Philips screws on the left side of the unit
30
Please adhere to the description in this manual when opening
the unit. Before removing the cover to gain access to the
internal components, the system must be powered down and
the power cord has to be disconnected from the power
source.
Please refer to the ESD safety procedures for handling
assemblies with static sensitive devices.
Failure to take heed of this warning instruction can result in
damage to the device.
JRex-IBOX – User's Manual
Advertisement
Table of Contents
