Dc Connection; Operating System And Hardware Component Drivers - Kontron Embedded Computers JRex-IBOX User Manual

DC Connection

For the DC connection please prepare the connecting wires with the provided
Phoenix terminal.
The length of the DC connecting wires may not exceed 10 m.
Strip and twist the connecting wire-ends but do not tin it the with
solder.
1. Loosen enough the two slotted screws of the provided Phoenix terminal, so
that you can insert the ends of the connecting wires. Pay attention to the
polarity of the connections (see fig. 19a ).
2. Tighten the slotted screw firmly.
The second end of each wire will be prepared as required for the connection to
the DC-power supply.
Connect JRex-IBOX to the DC power source, as follows:
1. Connect the prepared DC power cord end (with Phoenix terminal) into the DC
power plug of the JRex-IBOX (see fig. 19a ).
2. Connect the other end of the DC power cord into a corresponding outlet of the
DC power source.
Operating System and Hardware Component
Drivers
Your computer can optionally be supplied with or without pre-installed operating
system.
If you have ordered your JRex-IBOX with pre-installed operating system, all
drivers are installed, corresponding to the ordered computer configuration
(optional hardware components). Your computer is fully functional when you turn
it on for the first time.
If you have ordered your JRex-IBOX without pre-installed operating system, you
have to install the operating system and the corresponding drivers for the ordered
computer configuration (optional hardware components). In order to install the
operating system you might need in addition an external USB connected CD-
ROM drive .
The needed drivers can be downloaded from the web page:
http://www.kontron-em.com/techsup/softdrive.php
JRex-IBOX – User's Manual
Starting Up
29