Operation - McCulloch B26PS Operator's Manual

Hide thumbs Also See for B26PS:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
Fuel
This product has a two-stroke engine.
CAUTION: Incorrect type of fuel can result in
engine damage. Use a mixture of gasoline
and two-stroke oil.
Premixed fuel
Use Husqvarna premixed alkylate fuel for best
performance and extension of the engine life. This
fuel contains less harmful chemicals compared to
regular fuel, which decreases harmful exhaust
fumes. The quantity of remains after combustion is
lower with this fuel, which keeps the components of
the engine more clean.
To mix fuel
Gasoline
Use good quality unleaded gasoline with a maximum
of 10% ethanol contents.
CAUTION: Do not use gasoline with an
octane grade less than 90 RON/87 AKI.
Use of a lower octane grade can cause
engine knocking, which causes engine
damages.
Two-stroke oil
For best results and performance use Husqvarna
two-stroke oil.
If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION: Do not use two-stroke oil for
water-cooled outboard engines, also
referred to as outboard oil. Do not use oil
for four-stroke engines.
To mix gasoline and two-stroke oil
Gasoline, liter
1228 - 002 - 08.09.2020

Operation

5
10
15
20
(Fig. 50)
1. Fill half the quantity of gasoline in a clean container
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
5. Carefully shake the fuel mixture.
To fill the fuel tank
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap. (Fig. 51)
3. Shake the container and make sure that the fuel is
4. Remove the fuel tank cap slowly to release the
5. Fill the fuel tank.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
Two-stroke oil,
liter
Note: To see where the fuel tank is on your product,
2% (50:1)
refer to
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
for fuel.
container.
CAUTION: Do not mix fuel for more than 1
month at a time.
WARNING: Obey the procedure that follows
for your safety.
fully mixed.
pressure.
CAUTION: Make sure that there is not
too much fuel in the fuel tank. The fuel
expands when it becomes hot.
refueling area and fuel source before you start the
engine.
Product overview on page 6 .
0.10
0.20
0.30
0.40
13

Advertisement

Table of Contents
loading

Table of Contents