Connecting The Intellex To A Network - American Dynamics Intellex Intellex DVMS Installation And Configuration Manual

8-Channel
On an 8-channel Intellex, the alarm adapter is a rectangular board that connects into the DB37
port. The pinout looks like this:
Pin No.
1
G
2
G
3
G
4
G
5
G
6
G
7
G
8
G
17
G
18
G
8-Channel
The DB37 alarm port of the 8-channel Intellex can also be used without the alarm adapter. In that
case the pinout looks like this:

Connecting the Intellex to a Network

Only connect the Intellex to a network if you have installed the Network Client, Browser Client, or
other software designed to connect to an Intellex on the network. Use shielded twisted-pair cable
for network operation.
Connect the cable from the local area network to the Ethernet 10/100 port. Use Category 5
twisted-pair Ethernet cable (CAT 5 TPE).
Alarms In
Assignment
Input 1
Ground
Input 2
Ground
Input 3
Ground
Input 4
Ground
Input 5
Ground
Input 6
Ground
Input 7
Ground
Input 8
Ground
Time Sync
Ground
Ground
Ground
Alarms Out
Pin No. Assignment
1 Output 1
G Ground
2 Output 2
G Ground
3 Output 3
G Ground
4 Output 4
G Ground
5 Output5
G Ground
6 Output 6
G Ground
7 Output 7
G Ground
8 Output 8
G Ground
16 Output 16 (Unit Alarm)
G Ground
COM Reserved
G Ground
Installation and Configuration Guide 15
Installing Hardware