Advertisement
Set Up Procedure
Every System is different!
1. Inspect the system design drawings,
compare with all the parts received.
2. Inspect all the locations of where the
components will be installed, look for:
(a) Proper support points.
(b) Obstructions
3. Starting at the Central Vac's main
components install and anchor the hanger
manifold.
4. Install the airlock and fasten it to the
hanger manifold.
5. Run a bead of silicone around the top lip
13. For ease in maintenance install all compression couplings facing the same way.
(a) This created minimal movement when removing any couplings.
14. When installing the camlock couplings, ensure that the dust cap is installed and
clamped on, before applying silicone to the piping and installing the camlock coupling.
of the airlock,
and then
position the
primary separator with the 6" outlet port facing towards the
secondary separator.
6. Install the secondary separator.
(a) Ensure that silicone is applied between any of the
secondary separator parts.
7. Install the 6" pipe and 6" compression couplers in between
the separators.
8. Along the side of the hanger manifold, install the filter
housing.
(a) Install the filter inside the basket at the bottom of the
filter cannister.
9. Run the 6" piping along with the 6" elbows and 6"
compression couplers from the secondary separator, out
of the top, down to the inlet port on the side of the filter
housing.
10. Place the Blower package close to the hanger manifold
and run your 6" piping from the top of the filter housing to
the blower inlet.
11. Refer to the supplied system drawing to map out the
location of the piping.
12. When joining piping, ensure that the grounding strip is
present on all compression couplers. Do not leave gaps
between piping sections or between piping and elbows.
Gaps will lead to premature wear of piping and create
holes in couplers and gaskets.
Advertisement
