D-Link DCS-4612EK User Manual page 59

Section 3: Configuration
Here you can set the Simple Network Management Protocol (SNMP) settings for the camera. After making any changes, click the Save button.
Enable this option to allow for SNMPv1 and SNMPv2c management of the
Enable
camera.
SNMPv1/v2c
Enter a name for the R/W community of your SNMP server.
Read/Write
Community
Enter a name for the read-only community of your SNMP server.
Read-Only
Community
Enter the IP address where SNMP traps should be sent.
Trap Address
Enter port of the IP address to which the trap messages will be sent.
Trap Port
Enter the SNMP trap community name.
Trap
Community
D-Link Vigilance H.265 Outdoor Bullet Camera User Manual
SNMP
DCS-4618EK
59