Vuly Quest Large Manual page 17

21
STEP
A. Slide the Long Side Rail and Short Side Rail into the Top
Rails above the climbing bars.
Important: Ensure that your frame matches the below –
particularly the Shade Tubes.
22
STEP
A. Slide a Flip Rail (C1) into one end
of an Angled Joiner (C3), and a Flip
Tube (C2) into the other. Insert a
Foot (B5) into the bottom.
23
STEP
Insert the completed flip sections into the T-Joiners
around the frame, as indicated below for your model.
Important: Make sure the outer sections are positioned
at 45º, relative to the climbing frame section.
If you are installing a Flying Fox attachment.
B.
Position your Flying Fox Rail and connectors here.
C1
C3
C2
B5
WARNING: Do not force any part
too far into the Angled Joiner. This
will block the part on the other side
from connecting completely.
B. Repeat for the 3 remaining Flip Rails,
Angled Joiners, Flip Tubes and Feet.
17