Advertisement
3.0 Preparation for Use
1. Plug unit power cord into the power source.
2. Connect a compressed air supply line to the inlet located on the Pre-Filter.
3. Turn the unit on by depressing the power switch. The Unit will immediately begin to
produce nitrogen. The nitrogen pressure gauge located on the Unit will indicate the nitrogen
pressure in the system and/or the optional external storage tank.
4. The Unit is ready for use when the nitrogen pressure gauge indicates a pressure of 130psi
(9.0bar/900kPa) or greater.
WARNING
To avoid the risk of personal injury, especially to the eyes, face or skin DO NOT direct the air
stream at any person(s).
CAUTION
To avoid equipment damage, never exceed the maximum inlet pressure.
5
Advertisement
