Advertisement
Description
Generator Unit
Hose with Couplers (1 meter/39 Inch)
Tire Fill Hose
Hose/Cord Storage Hook
Storage Tank Base
2. Install the
1
provided Hose/Cord Storage
3. If using an optional storage tank, install the Storage Tank Base to the main Base Frame
with the provided hardware. Bolt the storage tank to the Storage Tank Base. Using the
provided 39 inch Hose with Couplers, connect the storage tank to the Outlet port located on
the reverse side of the Unit.
4. Connect a compressed air supply to the air inlet located on the Pre-Filter. This inlet
accommodates any ¼" nipples or air line fittings.
5. Connect the Tire Fill Hose to the outlet coupling located on the Unit.
6. Place the Tire Fill Hose on the hook.
Air Supply Caution
Compressed air should be supplied to the unit with the air dried to a dew point temperature
lower than the expected minimum ambient temperature. Typical dew point from a properly
sized refrigerated air dryer is sufficient (+40°F, 4°C). No water in liquid form should be
present. Inlet air pressure must be less than
2.1 Nitrogen Tire Inflator - Exploded View
Quantity
1
1
1
1
1
Hook
onto the Unit with the screws provided.
217
PSI.
4
Advertisement
