Important Information - Bang & Olufsen BeoPlay A8 Manual

44
English (English)
Electrical and electronic
equipment, parts and
batteries marked with
this symbol must not be
disposed of with normal household
wastage, it must be collected and
disposed of separately to protect
the environment.
Your Bang & Olufsen retailer will
advise you of the correct way of
disposal in your country.
This product complies with
applicable environmental
legislation throughout the world.
Hereby, Bang &
Olufsen declares
that this audio
product, BeoPlay A8 is in
compliance with the essential
requirements and other relevant
provisions of Directive 1999/5/EC.
The declaration of conformity may
be consulted at www.bang-
olufsen.com/guides.
AT, BE, BG, CH, CY, CZ, DE, DK, EE,
ES, FI, FR, GB, GR,HU, IE, IS, IT, LI,
LT, LU, LV, MT, NL, NO, PL, PT,
RO,SE, SI, SK, TR
This equipment should be installed
and operated with minimum
distance 20 cm between the
antenna and your body.
For the US-market only!
NOTE: This equipment has been
tested and found to comply with the
limits for a class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against
harm ful interference in a residen-

Important information

tial installation.
This equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions,
may cause harmful interference to
radio communications. However,
there is no guarantee that interfer-
ence will not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equip-
ment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between
the equipment and receiver.
– Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
– Consult the retailer or an
experienced radio/T V technician
for help.
Changes or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to operate
the equipment.
This device complies with part 15
of the FCC Rules. Operation is
subject to the following two
conditions:
(1) This device may not cause
harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
For the Canadian market only!
This device complies with Industry
Canada licence-exempt RSS
standard(s). Operation is subject to
the following two conditions:
(1) this device may not cause
interference, and
(2) this device must accept any
interference, including
interference that may cause
undesired operation of the
device.
Under Industry Canada regulations,
this radio transmitter may only
operate using an antenna of a type
and maximum (or lesser) gain
approved for the transmitter by
Industry Canada. To reduce
potential radio interference to
other users, the antenna type and
its gain should be so chosen that
the equivalent isotropically
radiated power (e.i.r.p.) is not more
than that necessary for successful
communication.
This equipment complies with IC
RSS-102 radiation exposure limits
set forth for an uncontrolled
environment. This equipment
should be installed and operated
with minimum distance 20 cm
between the antenna and your
body.
This Class B digital apparatus
complies with Canadian ICES-003.