G.S.M Activate 3G RF DOOR Manual
  1. Manuals
  2. Brands
  3. G.S.M Activate Manuals
  4. Security System
  5. 3G RF DOOR
  6. Manual

G.S.M Activate 3G RF DOOR Manual

2g & 3g gsm door contact alarm
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
2G & 3G
GSM Door Contact Alarm
www.gsm-activate.co.uk
MODEL RF - PIR

Advertisement

Table of Contents
loading

Related Manuals for G.S.M Activate 3G RF DOOR

Summary of Contents for G.S.M Activate 3G RF DOOR

  • Page 1 2G & 3G GSM Door Contact Alarm www.gsm-activate.co.uk MODEL RF - PIR...

  • Page 2: Product Information

    Product Information Our 2G/3G GSM Door Contact Alarm is a standalone alarm system for smaller rooms inside properties. It will alert you using GSM technology by sending you a text message and/or phone call to your mobile phone or landline when the sensor has been broken alerting you to a possible intrusion.

  • Page 3: Signal Strength

    Instructions Slide the simcard into the holder making sure that the clipped corner of the simcard lines up with the clipped corner of the simcard holder as seen in the picture above. IMPORTANT - PLEASE READ PLEASE MAKE SURE YOU DISCONNECT THE POWER WHEN YOU FIT THE SIM CARD THEN PLACE THE SIM CARD IN WITH THE CLIPPED CORNER FACING UPWARDS.
  • Page 4 How to Programme Mobile Numbers After inserting the simcard into the GSM module, turn the unit on and wait until you see the GREEN LED is on. This indicates that the module has a signal and the unit is ready for use.
  • Page 5 How to programme the SMS text message You can now change the alarm message from “input detected” to one of your own choice. To change the message send the text command as follows #MESS=YOUR MESSAGE# The detector will reply with a text message - MESSAGE STORED PLEASE NOTE You can only use a maximum of 19 characters including spaces for your customised message.
  • Page 6 How to use the 2G/3G Door Contact Alarm Once you have positioned the door contact, the system is now ready to use. The GSM Door Contact Alarm has two modes, Alarm Mode and Auto Mode. In alarm mode, you have to arm your alarm manually when required. In auto mode, the alarm is always armed.
  • Page 7 Pairing the Wireless Door Sensors To connect wireless door sensors you will need to go through a process so that the devices are matched to the receiver on the dialler. 1. Hold down the pairing button on the RF Module for 3 seconds (refer to figure 1) 2.

  • Page 8: Quick Reference

    Quick Reference FACTORY RESET To set the unit back to factory settings you will need to send a text message #RESET# Please Note - doing this will reset ALL of your parameters. Only send a reset command when necessary. GREEN ready LED will flash eight times.

This manual is also suitable for:

2g rf door

Table of Contents