G.S.M Activate 3G RF DOOR Manual page 5

How to programme the SMS text message
You can now change the alarm message from "input detected" to one of your own choice.
To change the message send the text command as follows
#MESS=YOUR MESSAGE#
The detector will reply with a text message - MESSAGE STORED
PLEASE NOTE
You can only use a maximum of 19 characters including spaces for your customised
message.
The Door Contact Alarm can be programmed to send you a telephone call after each text
alarm has been sent.
You will receive approximately three ring tones. The unit will then hang up automatically.
This is to prevent call charges being incurred.
To text call alerts to ON please send the text message
#CALL=ON#
The unit will reply back with the message - CALL ON
To disarm call alerts please send the text message.
#CALL=OFF#
If the call function has been set to ON you will receive a text message and shortly after a
phone call.
Telephone Call Alerts
Page 5