Advertisement
Hooking Up Speaker Cables
The Push-in Spring Terminals can accommodate up to 14AWG speaker cables.
It is recommended to leave about 150 cm (5 feet) of extra cable at the selector end to
facilitate positioning and installation of the selector. Do not use staples, nails or other
metal objects to secure the cables.
You will get the best sound quality and least amount of hum by keeping the cables
away from other electrical wires and cables.
Pay attention to connecting the polarity of the selector correctly with the audio source
(amplifier, receiver etc.) and speakers in each speaker group (RED + terminal
with RED + amplifier / speaker connector, BLACK – terminal with BLACK – amplifier
/ speaker connector).
Before connecting make sure that your audio source is turned off.
Do not let bare speaker wires touch each other or any metal part
of this unit.
It can damage this unit and/or audio source / speakers.
Please refer to your audio source / speaker instruction manual for more information.
Connecting Audio Source and Speakers
Amplifier, receiver etc.
Additional Speaker Selector
6
Speakers in Zone #3
Speakers in Zone #4
Speakers in Zone #1
Speakers in Zone #2
Advertisement
