This device is a 2-source, multizone speaker selector with a separate volume regulation for each zone (room) / speaker pair (1 pair per zone). TAGA Harmony speaker selector is a device which is an efficient, cost-effective way of expanding an audio system at home or commercial venues (bars, cafes, restaurants, shops, conference rooms etc.) into a complex multi-room sound system.
Safety Instructions 1. Read Instructions – All the safety and 9. Object and Liquid Entry - Never push operating instructions should be read objects of any kind into this product before the product is operated. through openings as they may touch dangerous voltage points or short-out 2.
Front and rear panel Volume regulators Zone selectors Source amplifier selectors Pin Screw Terminal Connectors Inputs for Amplifier (Receiver) A and B Speaker Output to Zones (TVS-4 model shown)
Setting the number of speakers The Speaker Selector works with all speakers rated from 4 to 8 Ω and audio sources (amplifiers, receivers etc.) rated for 4 and 8 Ω loads. The Speaker Selector is shipped with the factory setting allowing to connect 1 pair of speakers to each zone. If you plan to use more speakers than 1 pair per zone then you have to change the setting of jumper shunts which are located on the main board of the Speaker Selector.
Page 6
Setting the number of speakers Impedance matching for 8Ω rated amplifiers Pairs of 8Ω speakers Pairs of 4Ω speakers Impedance matching for 4Ω rated amplifiers Pairs of 8Ω speakers Pairs of 4Ω speakers If necessary remove each jumper shunt and place it in the required position (X1, X2 etc.).
Page 7
Setting the number of speakers Note! Connecting more speakers than the maximum quantity allowed and/or speakers/ audio sources outside the permitted impedance range can damage connected devices or this product. This may void your warranty.
Hooking Up Speaker Cables to Terminals The pin screw terminal connectors can accommodate up to 14 AWG speaker cables. 14 AWG speaker cable is recommended for longer connections (greater than 20 meters / 66 feet). For shorter lengths you can use 16 or 18 AWG speaker cables. It is recommended to leave about 150 cm (5 feet) of extra cable at the speaker selector to facilitate positioning and installation of the speaker selector.
Operation Make sure your audio sources (amplifiers, receivers etc.) are switched off. Make sure that the volume regulators on your audio sources are set to minimum. Make sure that the Volume Regulators on your Speaker Selector are set to minimum. Switch OFF all Zones on the Speaker Selector (Zone Selectors switched in the top position).
Page 11
We strongly advise to contact a professional installer or dealer in order to install TAGA Harmony products. We recommend using high quality TAGA Harmony cables and other installation accessories. Your product is marked with the symbol as showed on the left.