The RMS power of the audio source should not exceed the power
supported by this speaker selector otherwise this unit, audio source
and / or speakers may be damaged. This may void your warranty.
In the
OFF position the protecting circuit is not operating - it can be useful if you
intend to use the speaker selector as a part of a planned system of impedance
matching volume regulatios, allowing you to get the most out of your amplifier
(receiver).
ON: Press down the protecting circuit switch (the switch in the
OFF: Press it again to switch off the protecting circuit (the switch in the
position).
The Protecting Circuit Switch „PROTECT" should be always
switched ON :
• when connecting more than a single pair of speakers to a single
zone.
• when connecting 4Ω-impedance speakers to the speaker selector.
Failure to follow the above recommendations may damage this unit,
audio source and / or speakers.
This may void your warranty.
The OFF option should be used only when speakers and audio so-
urce have been selected and connected by a professional installer.
Bypass Output:
Addittional Speaker Selector can be connected to this output in order to expand system
capabillities and to add extra zones (rooms).
ON position).
OFF