List:recorder - ITech IT-M7700 Series Programming Manual

ООО "Техэнком" Контрольно-измерительные приборы и оборудование
Query Syntax：
Returns：

LIST:RECOrder

LIST:CONFigure?
<String>
This command is used to set the record Arguments of a single Step in the List.
Record the Arguments format as: Step index value, "Type, Wave Type, Level,
Vac, Vdc, Freq, Time, Start Phase, Stop Phase, Kac, Kdc, Kfreq, Repeat".
Detailed Arguments are explained below.
Arguments Description
Step index Set the current Step number.
value
Set the single step type: 0|1 .
Type


Wave Type Set the single-step waveform type: 0~39.







Level Set the clipping percentage. This option is only valid when
the Clip Sine output waveform is selected.
Vac The AC voltage value set in a single step.
Vdc The DC voltage value set in a single step
Freq The frequency value set in a single step.
Time Dwell time for single step: 0~100000000ms.
Start Phase Start phase angle of single-step waveform.
Stop Phase Stop phase angle of single-step waveform.
Kac AC rising slope of single step.
Copyright© Itech Electronic Co., Ltd.
0: Time
1: Cycle
0：Sine
1：Square
2：Triangle
3：Saw
4：Clip Sine
5~34：THD1~THD30
35~39：USER1~USER5
www.tehencom.com
LIST Subsystem
63