Troubleshooting - Goddess WFE 1036 M10D Instruction Manual

EN

9. TROUBLESHOOTING

Repair of your machine should be carried out by an authorised service company. If your
machine requires repair or if you cannot solve an issue with the information provided
below, then you should:
• Unplug your machine from the mains power supply.
• Turn off the water supply.
FAULT
Your machine does
not start.
Your machine does
not intake water.
Your machine does
not discharge water.
Your machine
vibrates.
POSSIBLE CAUSE
Machine not plugged in.
Fuses are faulty.
No mains power supply.
Start/Pause button not pressed.
Programme dial 'stop' position.
The machine door is not
completely closed.
Water tap is turned off.
Water inlet hose may be
twisted.
Water inlet hose clogged.
Inlet filter clogged.
The machine door is not
completely closed.
Drain hose clogged or twisted.
Pump filter clogged.
Laundry is too tighly packed
together in the drum.
The feet have not been adjusted.
Transit bolts fitted for
transportation have not been
removed.
Small load in the drum.
Your machine is overloaded
with laundry or laundry is
unevenly spread.
Your machine rests on a hard
surface.
EN - 96
TROUBLESHOOTING
Plug machine in.
Replace the fuses.
Check mains power.
Press the Start/Pause button.
Turn the programme dial to the
desired position.
Close the machine door.
Turn tap on.
Check water inlet hose and
untwist.
Clean water inlet hose filters. (*)
Clean the inlet filters. (*)
Close the machine door.
Check the drain hose, then
either clean or untwist.
Clean the pump filter. (*)
Spread your laundry in the ma-
chine evenly.
Adjust the feet. (**)
Remove the transit bolts from
the machine. (**)
This will not prevent operation of
your machine.
Do not overload the drum.
Spread laundry evenly in the
drum.
Do not set up your Washing
Machine on a hard surface.