Port Ranges - Allied Telesis AT-x900-12XT/S Configuration Manual

Port Numbering

Port ranges

Continuous To configure a continuous range of ports at the same time, enter the range in either of the
formats:
portx.y.z-portx.y.z
portx.y.z-x.y.z
For example, to configure the same interface setting on base switch ports 10-20, enter the
Global Configuration mode command:
awplus(config)#interface port1.0.10-1.0.20
Non- To configure a non-continuous set of ports at the same time, enter the ports as a comma-
continuous separated list, like this:
portx.y.z,portx.y.z
For example, to configure the same interface setting on base switch ports 1 and 5, enter the
Global Configuration mode command:
awplus(config)#interface port1.0.1,port1.0.5
You can combine a hyphen-separated range and a comma-separated list. For example, to
configure the same interface setting on base switch ports 1-3 and 5, enter the Global
Configuration mode command:
awplus(config)#interface port1.0.1-1.0.3,port1.0.5
Page 4 | AlliedWare Plus™ OS How To Note: Switching