Link Aggregation; How To Configure Link Aggregation Control Protocol (Lacp) - Allied Telesis AT-x900-12XT/S Configuration Manual

Link Aggregation

This section has examples of two ways to aggregate ports together:
dynamically using LACP
statically, on
Both examples configure the AlliedWare Plus switch that is shown in the following figure.
How to configure Link Aggregation Control Protocol
(LACP)
1. Create the VLANs
Enter Global Configuration mode and enter the command:
awplus(config)#vlan database
This puts you into VLAN mode. To create the VLANs, enter the commands:
awplus(config-vlan)#vlan 2 name vlan2
awplus(config-vlan)#vlan 3 name vlan3
awplus(config-vlan)#vlan 4 name vlan4
Page 21 | AlliedWare Plus™ OS How To Note: Switching
page 24
vlan2
vlan3
vlan4
1.0.5 1.0.6
vlan2
vlan3
vlan4
Switch 2
AlliedWare Plus
Switch
1.0.2
1.0.3
1.0.4
1.0.5
1.0.6
1.0.8
1.0.9
Link Aggregation
1.0.8 1.0.9
vlan2
vlan3
vlan4
Switch 3
lacp.eps