How To Configure Static Aggregation - Allied Telesis AT-x900-12XT/S Configuration Manual

How to configure static aggregation

This section describes how to use statically-aggregated ports instead of LACP. For the
network diagram, see
First create the VLANs and associate them with ports, by following
step 2 on page
Then instead of creating channel groups
3. Create the static channel groups
Create a static channel group for each set of ports that you want to aggregate, by entering
the commands:
awplus(config)#interface port1.0.5-1.0.6
awplus(config-if)#static-channel-group 1
awplus(config)#interface port1.0.8-1.0.9
awplus(config-if)#static-channel-group 2
4. Check the configuration
Enter Privileged Exec mode and enter the command:
awplus#show static-channel-group
The output looks like this:
% Static Aggregator: sa1
% Member:
port1.0.5
port1.0.6
% Static Aggregator: sa2
% Member:
port1.0.8
port1.0.9
Page 24 | AlliedWare Plus™ OS How To Note: Switching
page 21.
22.
(step 3 on page 22), do the following steps:
Link Aggregation
step 1 on page 21 and