Advertisement
Package of Content
3.5" aluminum external enclosure.
Power adapter.
USB 1.1/2.0 connection cable.
IEEE 1394 connection Cable.(1394 + USB model only)
User's Guide.
Driver CD for WIndows98SE (USB mode only)
Screw TP 3 * 8 mm 2pcs for real panel.
Screw flat head M6#6 mm 4pcs for hand disk drive.
Screw flat head M 3*4 mm 4pcs for MO drive.
Ruber feet for lying down 4pcs.
Ruber stand for straight up 2pcs.
Ruber for real panel screw hole 2pcs
System Requirements
PC/AT compatible computer
Pentium class processor above 200MHz
Windows98SE, 2000, ME & XP
LINUX OS kernel 2.4.0 or later
64MB Memory or more
USB 1.1/2.0 and 1394 Interface
Apple Mac computer
G4 processor above 300MHz
OS 9.0 or later
64MB memory or more
USB1.1/2.0 and 1394 interface
The way to install the HDD/MO
Please set the Device as "Master Device"
How to set the ATA/ATAPI as Master, please reference your HDD or MO
user guide Usually the device is set at "Master" mode when delivering from
Factory. But once device connected with computer, the setting is possible
changed. So this should be noticed.
.
1
Advertisement
Table of Contents
Related Manuals for Rosewill RX32
Summary of Contents for Rosewill RX32
- Page 1 Package of Content 3.5" aluminum external enclosure. Power adapter. USB 1.1/2.0 connection cable. IEEE 1394 connection Cable.(1394 + USB model only) User's Guide. Driver CD for WIndows98SE (USB mode only) Screw TP 3 * 8 mm 2pcs for real panel. Screw flat head M6#6 mm 4pcs for hand disk drive.
- Page 2 The device needs to be set at " Master" (example) IBM HDD situation. (Attention) Thisis just setting an example, the exact setting of the HDD please reference your HDD user's guide. Remove the rear panel and take out the device frame. ¯...
- Page 3 Using the attached two screws TP 3*8 to secure the rear panel, and cover the screw hole with the rubber for the screw hole. 6. If you like to use the enclosure at lying down position. Please! use the rubber stand for lying down and assembly the rubber stand as the following figure.
- Page 4 Status LED: Green color: device at stand by mode. Orange Color: device at active mode. Status LED Using with the PC Start your computer and wait until Windows has been loaded. Turn on the power of enclosure. (The LED turns from orange to green as soon as the device (HDD/MO) is ready) Connect the USB or 1394 cable from the enclosure to corresponding port of your computer.
Need help?
Do you have a question about the RX32 and is the answer not in the manual?
Questions and answers