Advertisement
Quick Links
Tools Needed:
6mm Allen Key
Drill
Driver Bit
NOTE: Anchoring to floor or wall may require additional tools and hardware. See note at end of instructions.
Components:
A
B
C
D
E
17-15
Page 1 of 5
5mm & 4mm
Box Level
Allen Keys
Model
A
17-2424BL
B
17-175120EC
C
17-17597CP
D
17-LEVKIT
E
17-4896BDB (L/R)
Square One
Assembly Instructions
17-15 (LEFT & RIGHT)
Ladder
Tape
Measure
Description
Single Block, 24"x24"
(4 Bolts & Nuts Included)
End Cap, 120"
Corner Post, 97-3/4"
Leveler Kit, 2 Levelers
Barn Door Wall (Left or Right)
2 to 3
Installers
17-15
Quantity
54
3
(used horizontally)
4
(used vertically)
15
1
800.422.5727
www.IndianaFurniture.com
Advertisement
Related Manuals for Indiana Furniture Square One 17-2424BL
Summary of Contents for Indiana Furniture Square One 17-2424BL
- Page 1 Square One Assembly Instructions 17-15 (LEFT & RIGHT) Tools Needed: 6mm Allen Key Ladder 2 to 3 Drill 5mm & 4mm Box Level Tape Driver Bit Installers Allen Keys Measure NOTE: Anchoring to floor or wall may require additional tools and hardware. See note at end of instructions. Components: 17-15 Model...
- Page 2 Square One Assembly Instructions 17-15 (LEFT & RIGHT) 80mm bolt Begin by building the configuration 1 block high. To establish the configuration footprint. 60mm bolt Align the holes in blocks and connect with 2, 80mm bolts and 2, 17mm nuts. Fasten the bolt and nut together but do not over tighten because you will want to align and firmly tighten upon final setup.
- Page 3 Square One Assembly Instructions 17-15 (LEFT & RIGHT) Install 2, 97-3/4” Corner Posts using the 60mm bolts. Using a ladder and an assistant, install the 120” End Caps on the top of the unit using the 60mm bolts. Once everything is attached, go back and align components.
- Page 4 Square One Assembly Instructions 17-15 (LEFT & RIGHT) The model used in these instructions is a 17-4896BDBR which is a right hand unit. Note: For a 17-4896BDBL, left hand unit everything is mirrored, notes for left hand units will be in [ ]. Fasten together the two vertical sections with 80mm bolts and 17mm nuts to make up the right [left] side of the wall.
- Page 5 Square One Assembly Instructions 17-15 (LEFT & RIGHT) Attach the 2 half sections of the door together using 80mm bolts and 17mm nuts as shown. Note: Make sure that the groove along the bottom sides align. Lift the door up and set the rollers onto the rail. Take care to make sure the groove in the bottom of the door aligns with the guide bracket at the bottom of the configuration.