Adjusting The Contrast And Brightness; Remotely Controlling The Printer - Sony UP-960 Service Manual

Printing (Continued)
Variations of printouts
STD (standard) mode
NORMAL
SIDE mode
NORMAL
In addition to printouts introduced above, you can make the following variations
by changing the DIP switch settings.
• Making negative printouts. (See page 34.)
• Making mirror image printouts. (See page 38.)
• Making printouts upside down. (See page 37.)
44
Operation
SMALL
SMALL

Adjusting the Contrast and Brightness

You can adjust the contrast and brightness of the printout.
To adjust the contrast
You can adjust the contrast of printouts using the CONTR control.
To make the contrast stronger: Turn the CONTR control clockwise.
To make the contrast weaker: Turn the CONTR control counterclockwise.
To adjust the brightness
You can adjust the brightness of printouts using the BRIGHT control.
To make the brightness brighter: Turn the BRIGHT control clockwise.
To make the brightness darker: Turn the BRIGHT control counterclockwise.
Note
You cannot adjust the image once it has been captured in memory. Restore an
image after adjustment.

Remotely Controlling the Printer

You can remotely control the printer using the RM-91 remote control unit or the
FS-20 foot switch connected to the REMOTE connector on the rear panel.
Since the button on the remote control unit or foot switch functions exactly same as
the PRINT button, pressing either of them results in an image being captured and
immediately printed, when the INTERRUPT switch 8 of the DIP switches on the
rear panel is set to ON. (See page 38.)
45
Operation