Troubleshooting; Customer Service - Dometic MasterFlush 7600 Series Instruction Manual

Dometic MasterFlush Toilet
9

Troubleshooting

Problem
1 . Flush cycle operates correctly
but water in the bowl empties
slowly or not at all .
2 . Macerator pump makes
unusually loud noise or
continually trips breaker .
3 . Flush cycle is not activated after
pressing flush pedal .
4 . Insufficient or no water enters
the toilet bowl .
10

Customer service

10.1 Toilet model identification
The toilet model identification label is located on the back of the
toilet bowl under the base cover . Please have this information
ready if contacting Dometic for customer service .
10.2 Contact information
There is a strong, worldwide network to assist in servicing and
maintaining your toilet system . For the Authorized Service Center
near you, please call from 8:00 a .m . to 5:00 p .m . (ET)
Monday through Friday .
You may also contact or have your local dealer contact the Parts
Distributor nearest you for quick response to your replacement parts
needs . They carry a complete inventory for the Dometic product line .
Telephone:
Fax:
Web site:
10
a . Discharge piping is pinched or
kinked .
b . The macerator pump or
discharge piping is blocked .
a . Foreign material in pump
chamber .
a . Electrical power to toilet is
shut off or disrupted .
b . Flush pedal is malfunctioning .
c . Circuit board is malfunctioning .
d . Holding tank is full and signal
from tank has shut down
electrical power to toilet
(if tank level monitor system
is installed) .
a . Water supply line is pinched or
kinked .
b . Screen in water valve is blocked .
c . Water valve is malfunctioning .
1 800-321-9886
330-439-5550
330-496-3097
330-439-5567
http://www .Dometic .com
Troubleshooting / Customer Service
Possible Cause
U .S .A . and Canada
International
U .S .A . and Canada
International
Service Instruction
a . Check discharge piping .
b . Clear blockage .
a . Clear foreign material from pump
chamber .
a . Check wiring and circuit
breakers (or fuses) .
b . Replace switch in flush pedal .
c . Replace circuit board .
d . Empty holding tank .
a . Check water supply line .
b . Clear blockage at water valve .
c . Replace water valve .