Storage; Storing The Device; Longer Storage; Restarting - AS MOTOR Ride-on-Allmaher AS 800 FreeRider Operator's Manual

Storage

Storing the device

Keep the device in a closed, dry, and well vent-
ilated room and out of reach of children. Al-
ways eliminate all problems of the device be-
fore you store it so that the device is always in
a safe-to-operate state. Let the engine cool
down before you store the device in closed
rooms.
Also observe the notices on storage in the at-
tached operating instructions by the engine
manufacturer.

Longer storage

1. Observe the safety instructions for hand-
ling the fuel.
2. Emptying fuel tank: Place a piece of hose
onto the fuel valve and let the fule run into
an approved fuel container.
3. Emtyping carburetor: Start the engine and
let it run until it stops by itself.
4. Thoroughly clean the device.
5. Touch up any possible damage to the
paint finish (for paint, see Accessories).
6. Remove the ignition key and store it sep-
arately from the device.
Before longer storage, e.g. in the fall, have an
authorised service centre check the device!
Also observe the information regarding storage
in the operator's manual of the engine manu-
facturer.

Restarting

If you want to start the device after a longer
storage, carry out the tasks described in
chapter Maintenance.
32

Spare parts

The reliable and safe operation of the device
also depends on the quality of the spare parts
used. Only use original spare parts and ac-
cessories that were approved by
"AS-Motor Germany". When foreign parts are
installed, the warranty and guarantee shall be
void for the foreign part and for the device and
for any resulting damage.
Inform your authorised service centre about
the device type and serial number of your
devices when you order spare parts.

Wear parts

Some parts are wear parts. They wear during
use and must be replaced. The warranty does
not cover the following parts:
Blades, cutting blades, cutter bars, blade bolts,
sliding plates, V-belt, chains, Bowden cables,
starter ropes, pressure plates, air filters, spark
plugs, disc springs, lock washers, fuses, discs,
thrust plates, pressure discs, protection skirts,
impact protection, wheels, tires.

Disposal

The device cuts and shreds the plant material
in a single operation. Shredded plant material
decomposes quickly, can be utilized as fertil-
izer, and, therefore, be left on the ground.
Dispose of waste oil and fuel in accordance
with the local regulations or return it to an oil
shop.
Packaging, device, and accessories are made
of recyclable materials and must be disposed
of accordingly.

Warranty

Please see our AS-Motor website for warranty
information.
Please print out the documents that you re-
ceive during the online registration. Keep them
together with your sales receipt.