BRP Icon II 3.5” User Manual page 38

A pop-up warning and audible warning, or both, will remain in effect until acknowledged by the
operator. If a fault is active, it will be displayed in Active Faults information on the Engine 2
page.
Fault display depends on the instance configuration of the gauge (Port/Single used for single
engine configurations and port engines on twin engine configurations. Starboard selection
used for starboard engines on twin engine applications).
• EMM fault codes will only be displayed in the Engine 2 page on the gauge whose instance
matches the source of the fault code. For Example: If the Starboard EMM activates a
fault, that fault information can only be found in the Engine 2 page of the gauge that is set
to Starboard.
• Control head fault codes will only be displayed in the Engine 2 page on the gauge that is
set to Port/Single.
• Mechanical control module faults will only be displayed in the Engine 2 page on the gauge
that is set to Port/Single.
• Joystick module faults will only be displayed in the Engine 2 page on the gauge that is set
to Port/Single.
• Manifold controller will be displayed in the Engine 2 page on the gauge whose instance
matches the source of the fault code. For Example: If the Starboard EMM activates a
fault, that fault information can only be found in the Engine 2 page of the gauge that is set
to Starboard.
• Pressure sensor module faults will only be displayed in the Engine 2 page on the gauge
that is set to Port/Single.
36