INSTRUMENT PANEL CLEARANCES
Gauge Spacing (center to center)
• Minimum center distance - 4" (10.16 cm)
Instrument Panel Thickness
• Maximum panel thickness - 1" (2.54 cm)
Drilled Hole Size
IMPORTANT: Check space behind panel for adequate instrument clearance.
• 3 3/8 in. (86 mm)
FASTENING THE GAUGE
Insert instrument into panel hole. Install back clamp. Tighten nuts finger tight.
Electrical Connections
Connect the following:
• 2-pin deutsch connector to the warning horn (optional)
• 2-pin deutsch connector to the accessory power Y-connector
• the public network connector to the public network tee
For gauge connector identification, refer to CONNECTOR IDENTIFICATION.
TURNING THE DISPLAY ON
Turn the key switch to the On position or start the outboard to turn the display on.
NOTE: There is no power button on this gauge.
8