Menu Navigation - ABB CM-TCN Manual

reset is selected. With a rotate action section 2 will be entered. A frame will be
displayed around the first relay and the trip reason for this relay will be displayed
in the bottom line.
The device offers two reset options: automatic and manual reset. To reset a relay
manually when manual reset is enabled the push-rotate button needs to be
pressed when the frame is around the relay which should be reset.
The reset screen will open:
By clicking on
screen needs to be selected.
Example: In the picture displayed above, channel 1 shows a measured temperature
of 180.6 °C. Navigating the frame to relay 1 shows that it has tripped because the
configured threshold for overtemperature monitoring at 175 °C at channel 3 has
been reached.
Section 4 is used for devices with Modbus only. Here a symbol signalizes the work-
ing Modbus communication.
3.2.

Menu navigation

The operation of the device as well as the configuration is done via a push-rotate
button which allows a precise menu navigation and accurate setting of any value.
The encoder can be operated either with a screwdriver or with the delivered knob
which fits in into the screwdriver fitting.
STATUS
Approved
© Copyright 2020 ABB. All rights reserved.
a reset is conducted. To abort the reset and go back to the start
Default setting for all relays is automatic reset. In this case the re-
set menu will not be displayed. If manual reset is configured for a
relay, the reset menu will become available automatically. The re-
lay detects if the reset condition is reached. In case it is not
reached the reset menu will not be available.
SECURITY LEVEL
Public
S M ART T EMP ER ATUR E MONITORI NG R EL AYS
DOCUMENT ID.
2CDC112285M0201
REV. LANG. PAGE
B en 11/42