Qr-Code; Factory Reset - ABB CM-TCN Manual

7.1.7.

QR-code

Scanning the QR-code with a smartphone will lead to the web page for ABB low
voltage electronic relays and controls. On the page more information and details
about the temperature monitoring portfolio as well as other related products
can be found.
7.1.8.

Factory reset

A factory reset sets the device back to the delivery condition. All personal set-
tings and user profiles will be deleted. Maintenance counter which cannot be de-
leted by the user will be kept even after a factory reset. To make a factory reset
the user needs to click on the symbol.
Condition monitoring – factory reset
A confirmation pane will be displayed to ask again for confirmation. Confirma-
tion will lead to a factory reset.
Condition monitoring – confirmation factory reset
STATUS
Approved
© Copyright 2020 ABB. All rights reserved.
The simulation mode will stay active for 15 minutes if no user in-
teraction is detected. The symbol for simulation mode will be dis-
played on the bottom of the display.
It is advised to conduct a factory reset before disposing of the
device at the end-of-life.
SECURITY LEVEL
Public
S M ART T EMP ER ATUR E MONITORI NG R EL AYS
DOCUMENT ID.
2CDC112285M0201
REV. LANG. PAGE
B en 40/42