Filling The Salt Reservoir - Miele G 7966 Operating Instructions Manual

Filling the salt reservoir

Before filling the salt reservoir for the
first time, you must fill it with approx.
2 l of water to enable the salt to
dissolve.
Once the dishwasher has been used
once, there is always sufficient water
in the salt reservoir.
 Remove the lower basket from the
wash cabinet and unscrew the salt
reservoir cap.

Danger of corrosion due to saline
solution.
Water or saline solution will run out
of the salt reservoir when the cap is
opened. Salt solution that runs out
can cause corrosion in the wash
cabinet and to the wash items.
The cap should therefore only be
removed in order to refill the salt
reservoir.
 Fill the salt reservoir with approx. 2 l
of water (first use only).
Initial commissioning
 Place the funnel provided over the
salt reservoir and carefully fill with
reactivation salt until the reservoir is
full. The salt reservoir holds up to
2 kg of salt, depending on the type of
salt used.
 Clean off salt residues from around
the salt reservoir opening. Next,
screw the salt reservoir cap on again
firmly.
 Immediately after filling the salt
reservoir and each time you remove
the salt reservoir cap, run the
 65°C QuickIntenseWash program
with the  Express program option
selected without wash items in the
dishwasher to dissolve and remove
any traces of salt from the wash
cabinet.
29