Water Intake Fault - Miele G 7966 Operating Instructions Manual

Water intake fault

Problem
The in-operation
indicator light is
flashing quickly.
The alarm tone is
sounding.
One of the following
messages appears in
the display:

Open the water supply

Insufficient water. Open
the water supply all the way.
Refer to Operating
Instructions if necessary

Fault F 18: A technical
fault has occcurred. Turn off
the appliance, close the
water supply and contact
Miele Service.
The following fault
message appears
during the
EnergySaver
program:
Intake temperature too low
Frequently Asked Questions
Possible cause and solution
The water supply is turned off.
 Turn on the water supply fully.
Before remedying the fault:
 Switch the dishwasher off.
There is a problem with the water intake.
 Turn on the water supply fully and start the
program again.
 Clean the filter in the water intake (see "Cleaning
the filter in the water intake" under "Cleaning and
care").
 The water connection pressure is lower than
50 kPa.
Seek professional advice.
 The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see "Water drainage" under
"Installation").
A technical fault has occurred.
 Switch the dishwasher off.
 Turn off the water supply.
 Contact Miele Service.
The intake water has not reached the required
temperature of 45°C (see "Water intake" under
"Installation").
 Start the program again.
 If the fault message appears again, select a
different program.
99