Fault In The Autodos (Automatic Dispensing) - Miele G 7966 Operating Instructions Manual

Fault in the AutoDos (automatic dispensing)

Problem
The following message
appears on the display:
Insert PowerDisk or
deactivate AutoDos with
OK.
The in-operation
indicator light is
flashing quickly.
The alarm tone is
sounding.
The program does not
start or a program that
has already started
stops.
The following message
appears on the display:
AutoDos lid open
The following message
appears on the display:
PowerDisk empty.
Deactivate AutoDos with
OK.
The message
PowerDisk empty.
Deactivate AutoDos with
OK. appears in the
display even though you
have inserted a new
PowerDisk.
Frequently Asked Questions
Possible cause and solution
The AutoDos function is active but no PowerDisk has
been inserted.
 Insert a PowerDisk (see "Automatic
dispensing / AutoDos" under "Detergent").
 If you do not wish to use AutoDos, deactivate the
function using OK.
The AutoDos lid has not been closed properly.
 Close the AutoDos lid and lock it fully (see
"Automatic dispensing / AutoDos" under
"Detergent").
 If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see "Inserting a
PowerDisk" under "Detergent").
 If the same fault message appears again, contact
Miele Service.
The AutoDos function is active and the PowerDisk is
empty.
 Replace the PowerDisk (see "Automatic
dispensing / AutoDos" under "Detergent").
If you do not wish to use AutoDos, deactivate the
function using OK.
The dishwasher was turned off when the PowerDisk
was replaced and it has therefore not recognized the
new PowerDisk.
 Turn the dishwasher on before replacing the
PowerDisk (see "Automatic dispensing / AutoDos"
and "Inserting a PowerDisk" under "Detergent").
101