Troubleshooting; Total Reset Procedure For The Proline® Controller; Watering Cycle Pause Functions - Weathermatic Proline PL800 Owner's Manual

6.0 Troubleshooting

6.1 Total Reset Procedure For The ProLine® controller
A total reset will clear all programming data in the ProLine®
controller. All settings will return to factory defaults.
For all ProLine® models except PL800:
• Turn dial to Advanced Menu.
• While pressing the UP arrow button, use an open paper clip or
ballpoint pen to push in the Reset switch located on the back of
the operating panel. Release the reset button while continuing to
press and hold the UP arrow button.
• Once the display shows CLEARING, release the UP arrow button.
• Reprogram ProLine® controller.
For the PL800:
• Unplug the power supply on the side of the PL800.
• Turn dial to Advanced Menu.
• While continually holding down on the UP arrow button, reapply
the power connection to the PL800.
• The display will read "CLEARING" to verify that the Reset is
complete. Re-enter your controller settings.

6.2 Watering Cycle Pause Functions

ProLine® controllers will "pause" watering cycles in response to
certain sensor readings or program settings in the controller.
Pauses are a normal function of the controller. If a watering pause
occurs, the reason will be shown on the controller's display. The
table below provides a more detailed description of each message.
LANGUAGE SENSOR
LED Color LED Color
Red
Green Red
Green Red
Green Red
Green Orange
Orange Green
Orange Green
Orange Green
Orange Green
5.0 Advanced Menu
Display
Message Reason
Controller dial is set
to OFF
RAIN Rain sensor disks are
wet (SLW Only)
FREEZE Temperature is 37
degrees F or colder
(SLW Only)
SENS Sensor tripped at the
SEN terminals
RAIN Irrigation cancelled
DLY for additional hours in
SLW DLY (SLW Only)
Omit- Cycle paused for omit
Time hours set
SOAK Zone waiting for soak
time out
ZONE Waiting for next zone
DLY valve to open
PAUSE Waiting for MVP to
turn on or off
18