Weathermatic Proline PL800 Owner's Manual page 7

PGM Button: The ProLine® controller has 4
watering programs (A, B, C, and D). This
is like having 4 controllers in one. You
can assign zones to any program you like
or more than one program Display will
alternately show both programs while the
concurrent schedule is running. Program
D is normally used for micro irrigation with low flow and long run
times. Sprinkler zones should be assigned to A, B, or C.
START MANUAL PROGRAM Button:
Press to initiate a watering operation
when the programming dial is set to the
PROGRAM PROGRAM
RUN position. The ProLine® controller PGM PGM
will run Program A. Or, you can push the
NEXT NEXT
PGM button before you push the START
BACK BACK
MANUAL PROGRAM button to select
the program you want to run. You can
use the NEXT button to advance to other zones in a program that
you have started. Run Manual Program will override any omits or
delays.
Display with Program Running:
When a program is running, the screen
will display: program that is operating;
zone number that is operating; and run
time remaining. If the controller is in
PAUSE mode it is waiting for a programmed delay in the controller
to expire (run/soak, master valve delay, zone to zone delay, omit
time). The reason for the pause will be shown on the display.
Display with Dial In SYSTEM OFF Position:
When the ProLine® controller dial
is in the SYSTEM OFF position, the
processor and clock continue to
operate and all program values are
1.0 Getting acquainted with your ProLine® Controller
retained in the non-volatile memory. In the SYSTEM OFF position
no automatic watering will occur. If you move the dial to any
PROGRAM position other than RUN or SYSTEM OFF, and there is no control
PGM
panel activity for 30 minutes; the controller will return to the RUN
NEXT NEXT
mode, and the display screen will show the idle default screen or
BACK BACK
will return to a program in progress that was interrupted.
Note:
until the displays returns to the time of day.
LANGUAGE Button:
language button to change the
language of the controller's menus.
By default, the controller is in English.
PRESS TO START
Pressing the Language Button once
MANUAL PROGRAM
will change the controller's language to Spanish (Español) and
UP UP
the LED will reflect this change. Pressing the language button
DOWN DOWN
again will change the language to Italian (Italiano), Portuguese
(Português), or German (Deutsche) respectively. When the
language is set to any language besides English or Spanish, the
Language LED will not be illuminated.
which event has triggered the sensor. A program in operation
will also pause if you turn the dial to any position other than
RUN or SYSTEM OFF. The program in operation will resume
when you return the dial to RUN or if there is no programming
activity for 30 minutes.
PRESS TO START PRESS TO START
MANUAL PROGRAM MANUAL PROGRAM
UP UP
DOWN DOWN
If a station is running, the dial must remain in SYSTEM OFF
Press the
Note: No watering will take place when the
SENSOR LED is RED. This indicates a Rain, Freeze
or other type sensor has tripped, and programs
are prevented from running. The display will show
2
PROGRAM PROGRAM
PGM PGM
NEXT NEXT
BACK BACK
LANGUAGE ENGLISH
ESPAÑOL
ON ON
OFF OFF