Advertisement
Quick Links
Advertisement
Related Manuals for Weathermatic SmartLink SL-AIRCARDFLOW
Summary of Contents for Weathermatic SmartLink SL-AIRCARDFLOW
- Page 1 Commercial Wireless SmartLink Flow Aircard SL-AIRCARDFLOW Owner’s Manual...
- Page 2 Introduction Help Desk The SmartLink Flow Aircard provides web-based management of site flow conditions when a Weathermatic Online: support.weathermatic.com SLFSI Flow Sensor is installed on the system main line and Email: support@weathermatic.com connected to the SmartLink Flow Aircard. Telephone: 888-484-3776...
- Page 3 You may need to widen an flash red, please contact the Help Desk. http://support. existing hole using a drill or punch out weathermatic.com the area indicated on the bottom. Plug the Aircard cable into the RJ-11 jack located inside the controller. If the controller has two RJ-11 jacks (SL4800), either jack will work.
- Page 4 If creating a personal account, use your name existing Site. in place of the company name. Select the Site where you want the new SmartLine or ProLine controller to be place inside. Click "Add New Controller" and start by giving the controller a Name. http://support.weathermatic.com...
- Page 5 30-day temporary access activation. Note: If a subscription plan or credit card info is not entered prior to the expiration of the 30-day access, you will lose the ability to access the controller from SmartLink. http://support.weathermatic.com...
- Page 6 A SmartLine Controller with a SmartLink Flow Aircard can receive Flow data from ONE Flow Sensor. For additional configuration options with multiple Flow Sensors, contact your local Weathermatic representative or visit Weathermatic.com. Install the SLFSI Flow Sensor on the system main line after any Master Valve (Note: Master Valve not required).
- Page 7 This indicates a system mainline break has occurred. With a Master Valve installed, breaks in the http://support.weathermatic.com...
- Page 8 Flow Sensor brands. Line Fill Time: Choose the length of time in seconds that it takes the main and lateral lines to charge. Sample Time: Choose interval at which sampling of flow will occur. Currently fixed at 60sec (subject to change). http://support.weathermatic.com...
- Page 9 We recommend 3 to 5 program cycles for the most accurate number. The not been learned. column will only populate with flow data during the Aircard’s automatic nightly communication with the network. It cannot be populated manually. http://support.weathermatic.com...
- Page 10 The affected zone/s or the entire program automatically set the “Low/High Flow Limits” by using the “Low/High Flow Tolerance” % settings will be shutdown. you entered earlier in the “Global Flow Settings”. This will calculate the “Low/High Flow Limits” from http://support.weathermatic.com...
-
Page 11: Troubleshooting
(Contact distributor to upgrade.) Could not The connection timed out. Usually this is connect seen when the Aircard is unplugged or requires a reset (unplug, wait 10 seconds and plug back in). http://support.weathermatic.com... - Page 12 Commercial Wireless ADSLAC-MN-FLOW - RevC...