Reassigning Channels To Different Tracks - Alesis ADAT-LX20 Reference Manual

track 1 going to input 1, track 2 going to input 2, etc. (however, tracks can be re-
assigned to different inputs; see next section).
To create an exact (sample-accurate) digital copy from a master to a slave, both
master and slave machines must have their DIGITAL INPUT buttons enabled.
When bouncing audio from a master LX20 to a slave LX20, the slave does not need to
have its Clock set to DIG as it is already receiving accurate clock information
(shown by EXT in its display) from the master via the 9-pin cable.
R
EASSIGNING
Any incoming channel of digital audio can be rerouted to any track, or multiple
tracks.
Action
Choose digital source channels
to record
Choose tracks to which source
channels will be recorded
• The selected source channels are re-routed to the record-enabled destination
tracks, in ascending order. Example: Select source channels 1 and 5 and record-
enable tracks 3 and 4. Channel 1's will go to track 3, andchannel 5's audio will
go to track 4.
• If more destination tracks are selected than source tracks, the source tracks will
repeat (cycle). Example: If tracks 7 and 8 were added to the destination tracks
in the previous example, then source channel 1 would go to tracks 3 and 7, and
source channel 5 would go to tracks 4 and 8. This allows for copying a single
incoming channel to multiple tracks.
• No digital routing will occur if all 8 channels are selected as source tracks. If no
source channels are selected, any record-enabled tracks will be fed digital silence.
Rerouting channels using DIGITAL INPUT on the LX20's front panel will change
any routing sent from the optional BRC Master Remote Control. The BRC will not
display these changes.
ADAT LX20 Reference Manual
Chapter 10 - Multiple LX20/ADAT Operation
C D
HANNELS TO
You press...
Press and hold DIGITAL
INPUT, then the RECORD
ENABLE buttons that
correspond to the desired source
tracks
Release DIGITAL INPUT
button, then use the RECORD
ENABLE buttons to select the
tracks on which source channels
will be recorded
T
IFFERENT RACKS
You see...
The blue INPUT indicators will
light to indicate the selected
source channels
INPUT indicators return to
normal status, record-enabled
track indicators flash
59