Footswitches - Alesis ADAT-LX20 Reference Manual

Setting Up and Making Connections - Chapter 1
For each additional machine, connect one end of an additional fiber optic cable
to the second machine's DIGITAL OUT jack, and the other end to the third
machine's DIGITAL IN jack. Its DIGITAL OUT jack then connects to the fourth
machine's DIGITAL IN jack, and so on.
Finally, connect one end of a fiber optic cable to the last machine's DIGITAL
OUT jack, and the other end to the first machine's DIGITAL IN jack.
This last step creates a loop, making the digital bus accessible to all machines
connected to it.
The following diagram shows how to hook up the Sync and Optical Interface
connectors in a setup with two LX20s.
When connecting more than two machines, always connect the optical cables in the
same order as the sync cables (1 to 2, 2 to 3, etc.), so that the digital routing will
work correctly.
F
OOTSWITCHES
The LX20 provides one footswitch connector using a 1/4" stereo jack named
LRC/PUNCH.
• LRC allows patching in the LRC Remote control
• PUNCH is for punch in/out control using a footswitch.
16
LRC/PUNCH
Tip = LRC Remote
Ring = Punch In/Out
Sleeve = Ground
ADAT LX20 Reference Manual
INPUT
OUTPUT
INPUT
OUTPUT