Troubleshooting - Blue Diamond SEVERE DUTY BRUSH CUTTER Operation And Maintenance Manual

Troubleshooting

PROBLEM
Brush Cutter Vibrating.
Low Pressure At Startup / Blades
Turning Slow.
Hydraulic Pressure, But Blades
Not Rotating.
Poor Cutting.
Severe Duty Brush Cutter Operator's Manual
CAUSE
Broken or damaged blades.
Debris under deck or on blade
carrier.
Loose or missing blade bolts.
Hydraulic couplers are reversed.
Faulty relief valve on brush cutter
or machine.
Hi-Flow hydraulics not engaged (if
required).
Debris under deck or on blade
carrier.
Against an obstacle preventing
the blade carrier from rotating.
Drive is damaged or seized.
Damaged motor shaft or seized
motor.
Travel speed too slow.
Broken or dull blades.
Hi-Flow hydraulics not engaged (if
required).
Maintenance
SOLUTION
Check blades and replace as
needed.
Remove all debris and verify all
parts rotate freely.
Replace missing bolts and tighten
all blade bolts.
Reverse male and female. Check
for correct pressure.
Contact your dealer
Diamond Attachments
Department.
Engage Hi-Flow hydraulics.
Remove all debris and verify all
parts rotate freely.
Adjust brush cutter until blades
rotate freely.
Check blades and blade carrier.
Verify that blades
carrier rotate freely.
damaged or seized drive.
Contact your dealer
Diamond Attachments
Department.
Increase travel speed during
operation.
Replace blades as needed.
Engage Hi-Flow hydraulics.
or Blue
Service
and blade
Replace
or Blue
Service
31