Attachment Installation; Entering The Operator's Position; Leaving The Operator's Position; Connecting Attachment To The Machine - Blue Diamond SEVERE DUTY BRUSH CUTTER Operation And Maintenance Manual

Attachment Installation

IMPORTANT
See the machine's Operator's Manual for
detailed information on operating the loader.

Entering The Operator's Position

Use the attachment safety treads, handles and
steps (on the machine) to enter the operator's
position.
When in the operator's position, lower safety seat
bar, start the engine and release the parking
brake.

Leaving The Operator's Position

WARNING
AVOID SERIOUS INJURY OR DEATH
Before leaving the operator's position:
• Always park on a flat level surface.
• Lower lift arms and place attachment flat
on the ground.
• Place all controls in NEUTRAL.
• Engage the park brake.
• Stop the engine and remove the key.
• Wait for all moving parts to stop.
SEE MACHINE'S OPERATOR'S MANUAL
FOR ADDITIONAL INFORMATION.
Park the machine / attachment on a flat level
surface.
Severe Duty Brush Cutter Operator's Manual
Place all controls in neutral, engage the park
brake, stop the engine and wait for all moving
parts to stop. Leave the operator's position.

Connecting Attachment To The Machine

WARNING
CRUSH HAZARD
• Before moving the machine, look in all
directions and make sure no bystanders,
especially small children are in the work
area. Do not allow anyone between the
machine and
approaching
connecting.
• Keep fingers and hands out of pinch
points when
disconnecting attachment.
Before connecting to the attachment, inspect the
machine's mounting plate. (See the machine's
Operator's Manual for inspecting the mounting
frame).
Enter the operator's position. See "Entering The
Operator's Position" on page 19.
Drive the machine slowly forward, until the top
edge of the machine's mounting plate is under the
top flange of the attachment mounting frame.
Operation
attachment when
the attachment
connecting and
for
19