Connecting Hydraulic Hoses; Connecting Safety Chain; Disconnecting Hydraulic Hoses; Disconnecting Attachment From The Machine - Blue Diamond SEVERE DUTY BRUSH CUTTER Operation And Maintenance Manual

Operation
Connecting Attachment To The Machine
Cont'd
Slowly tilt the machine's mounting plate back until
the attachment mounting frame fully contacts the
front of the machine's mounting plate.
Leave the operator's position. See "Leaving The
Operator's Position" on page 19.
WARNING
AVOID SERIOUS INJURY OR DEATH
The locking pins / wedges must extend
through the holes
mounting frame. Failure to secure locking
pins / wedges can allow attachment to come
off.
SEE MACHINE'S OPERATOR'S MANUAL
FOR ADDITIONAL INFORMATION.
Engage attachment locking levers / wedges (See
the machine's Operator's Manual for detailed
information).

Connecting Hydraulic Hoses

IMPORTANT
• Thoroughly clean the quick couplers
before making connections. Dirt can
quickly damage the hydraulic system.
Remove dirt or debris from the male and female
couplers. Visually inspect the couplers for
corroding, cracking, damage, or excessive wear.
Replace as needed.
Connect the attachment hydraulic hoses to the
machine. Pull on each hose to verify full
connection is made.
20
in the attachment

Connecting Safety Chain

Connect the safety chain under the machine's
attachment mounting plate and secure to the
frame of the machine.

Disconnecting Hydraulic Hoses

WARNING
AVOID BURNS
Hydraulic fluid, tubes, fittings and quick
couplers can get hot during operation. Be
careful when connecting and disconnecting
hydraulic hoses.
Relieve auxiliary hydraulic pressure. (See the
machine's Operator's
procedure.)
Disconnect attachment hydraulic hoses from the
machine.
Disconnecting Attachment
Machine
Relieve auxiliary hydraulic pressure. (See the
machine's Operator's
procedure.)
Park the machine and attachment on a flat level
surface. Lower the attachment flat on the ground.
Leave the operator's position. See "Leaving The
Operator's Position" on page 19.
Disconnect attachment hydraulic hoses from the
machine.
Disengage locking pins / wedges. (See the
machine's Operator's
procedure.)
Enter the operator's position. See "Entering The
Operator's Position" on page 19.
Slowly tilt the machine's mounting plate forward
until the attachment mounting frame is free from
the machine's mounting plate.
Drive the machine slowly backward, away from
the attachment.
Severe Duty Brush Cutter Operator's Manual
Manual for correct
From The
Manual for correct
Manual for correct