Maintenance
Cleaning The Attachment
DANGER
AVOID SERIOUS INJURY OR DEATH
Before servicing the Brush Cutter:
•
Disconnect attachment hydraulic hoses.
•
Raise the lift arms and tilt brush cutter
fully forward (down) until the front of the
brush cutter contacts the ground.
•
Engage parking brake, stop engine and
exit the machine.
Park the machine and attachment on a flat level
surface. Lower the attachment flat on the ground.
Leave the operator's position. See "Leaving The
Operator's Position" on page 19.
Disconnect attachment hydraulic hoses from the
machine.
Disconnect safety chain from machine.
Enter the operator's position. See "Entering The
Operator's Position" on page 19.
30
Figure 6
Start the engine, slowly raise the machine's lift
arms, while tilting the brush cutter forward (down)
until the front of the brush cutter contacts the
ground [Figure 6].
Stop the engine, engage parking brake and leave
the
operator's
position.
Operator's Position" on page 19.
Use water or air pressure to clean debris from
under the brush cutter deck.
Be careful when removing any obstructions that
are wrapped around blades and blade carrier.
Severe Duty Brush Cutter Operator's Manual
See
"Leaving The