Table of Contents
Advertisement
P sensor
Description
P sensor (includes Mylar screw/POGO cover, bottom thermal Mylar, side thermal Mylar, and thermal
grease)
Before removing the P sensor, follow these steps:
1.
Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2.
Disconnect all external devices connected to the tablet.
3.
Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4.
Remove the display panel assembly (see
components:
a.
Mylar shield (see
b.
Battery (see
c.
Thermal solution (see
d.
Solid-state drive (see
e.
WWAN module (if applicable) (see
f.
System board (see
g.
WLAN antennas (see
h.
Speakers (see
Remove the P sensor:
1.
Lift the two gaskets from on top of the P sensor (1).
2.
Peel the two ends of the P sensor from the tablet (2) that secure the P sensor to the tablet.
Display assembly on page
Mylar shield (WWAN models only) on page
Battery on page
40)
Thermal solution on page
Solid-state drive on page
WWAN module (select models only) on page
System board on page
WLAN antennas on page
Speakers on page
68)
32), and then remove the following
37)
38)
42)
61)
65)
Component replacement procedures
Spare part number
L14798-001
44)
73
Advertisement
Table of Contents
