Table of Contents
Advertisement
Mylar shield (WWAN models only)
Description
Mylar shielding foil kit (for use only in models with a WWAN module)
Before removing the Mylar shield, follow these steps:
1.
Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2.
Disconnect all external devices connected to the tablet.
3.
Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4.
Remove the display panel assembly (see
Remove the Mylar shield:
▲
Peel the Mylar shield off the tablet (1), while holding down the M.2 solid-state drive cover (2).
IMPORTANT:
the Mylar shield, which can result in disconnection of one of the antenna cables from the WLAN module.
Reverse this procedure to install the Mylar shield.
Be sure to hold down the M.2 solid-state drive cover, or it may also be disengaged with
Display assembly on page
Component replacement procedures
Spare part number
L14793-001
32).
37
Advertisement
Table of Contents
