Battery - HP ENVY x2 12 Maintenance And Service Manual

Battery

Description
3-cell, 49-WHr, 4.365-AHr, Li-ion battery ( (includes Mylar screw/POGO cover, bottom thermal Mylar,
side thermal Mylar, and thermal grease))
Battery connector bracket
Before removing the battery, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the display panel assembly (see
5. Remove the Mylar shield (see
Remove the battery:
1. Remove the remaining Phillips M 2.0×2.0 screw (1) from the bracket on top of the battery connector.
2. Remove the bracket from the tablet (2), and then disconnect the battery cable from the system board
(3).
3. Remove the Phillips PM2.0×2.0 screw (1) that secures each USB Type-C port bracket to the tablet, and
the lift the brackets from the tablet (2).
40 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Display assembly on page
Mylar shield (WWAN models only) on page
Spare part number
924961-856
L14782-001
32).
37).