Installing the Extrusion Upgrade kit
Removing the print head
•
Slide a print head axis (dis)assemble tool on either side
of the left sliding block until it clicks into the axle.
•
Pop up the print head shaft until it comes out of the
sliding block at this side.
•
Do the same on the right side.
•
Repeat the steps 2 and 3 on the front and back, using
the print head axis (dis)assemble tools upside down.
•
Turn all sliding blocks away from the print head.
•
Move the print head so the shafts move out of the
sliding blocks and lift upwards. Set the print head
aside, you do not need anymore.
A C A D E M Y